Grip 710 S

Maximum contact surface, support and comfort

Pulled up

The raised end of the handle supports the outside of the hand, providing support and protection. The pressure is distributed evenly over a large area.

Hand edge

Higher on the outside than on the inside. This corresponds to the natural position of the hand. Ulnar nerve and especially the carpal tunnel exit, with the median nerve, are excellently relieved. The outer edge of the hand is slightly more stressed. However, this is rather insensitive, as karate fighters often impressively demonstrate. 

Grip safety

Ergobar and non-slip materials: a wave-shaped elevation on the underside of the grip, which precisely reproduces the shape of the angled fingers, provides an edge to hold on to and therefore a secure grip during sudden braking and abrupt riding maneuvers. The high-quality material of the 702 grip also offers excellent grip, even in wet conditions, so you can always keep control of your bike.

The perfect fit

The perfect fit for a bicycle grip is crucial for comfort and grip safety.

The grip width is the measurement from the tip of the middle finger to the crook of the thumb. This is exactly where you enclose the handle. The grip sizes differ in diameter, length and shape.

Grip size measurement

VSF certified - BEST ERGONOMICS

“SQlab's shape and size concept offers an outstanding selection of different grips for every purpose. The ergonomic shape effectively supports the hands, while the unusual grip edge ensures “grip” and greater riding safety. All models are available in three sizes, which are different in diameter, length and shape.” VSF

Pressure measurement in the SQlab laboratory

Pressure measurements are carried out with an electronic pressure measuring foil/mat. We have been using pressure measurement in saddle development since the beginning, i.e. for 15 years. 

Together with a manufacturer of pressure sensors, we were able to further develop the system and make it flexible enough to be able to wrap the pressure mat around the handle. Some of our premium dealer partners also use our pressure measurement system for advice.

Carpal tunnel

A kink in the wrist - especially a laterally hyperextended wrist - can narrow the carpal tunnel. Similar to a bent garden hose through which water no longer flows, nerve information can no longer be transported through the constricted carpal tunnel.

This problem occurs to healthy people only when the joint is “blocked”. The cause is almost always handlebars with too little bend to the rear.

Relief of carpal tunnel outlet

The relief wing must be placed as far out as possible to keep the carpal tunnel opening largely free and reduce pressure. Even slight but constantly repeated pressure over a long period of time can lead to problems such as carpal tunnel syndrome.

Relief of the ulnar nerve 

Pressure measurements show that the maximum pressure usually occurs on the outside of the palm. This is where the ulnar nerve runs, which supplies the two little fingers. 

Setting relief sash

We recommend 150° to 160°. Ideally, the extended line of force of the forearm runs through the middle of the grip. Recommendations between 180° and 165° are currently very common, but can become dangerous if forward support is no longer guaranteed during heavy braking. The SQlab relief wing is not intended to correct the hand, but merely to support it.

Comfort upgrade

Existing 710 and 702 handles can easily be retrofitted with the Innerbarend® 410/402.